Enter to open, arrow keys to move, Esc to close

    My Fall Semester

    1. Mid-September

      Test plans

      Wrote the Plan B testing strategies for all 3 unmet needs

    2. September 18

      Human subjects testing

      Wrote the testing document

    3. Late September

      Storyboard

      Drew both storyboard scenes

    4. October 6

      Topic chosen

      Team picked the rotating dispenser and detection cup

    5. October 16

      Regulatory strategy

      Wrote Step 1 and the regulatory pathway, then edited the full document

    6. Late October

      Canvas, plan, features

      Put together our GA8 submission, in charge of ordering parts

    7. October 30

      Use cases and hazards

      Wrote 7 alternate scenarios and 13 biological and chemical hazards

    8. November

      Prototyping

      Assigned to 3d print the mid-resolution prototype due November 13

    One dose at a timeRotatingdispenserDose-removalcupCaregiverappThe alert continues until the dose is taken

    The Device

    The cup uses a weight sensor to tell when the dose has been removed. It does not confirm the medication was actually swallowed.

    Hand-drawn storyboard scene: six cap and closure concepts labeled locking, locking with smoothed square, wide and oblong, special lid mechanism and label, clock on cap, and slots for hand
    Hand-drawn storyboard scene: test rigs for the torque needed to open a cap, cap tensile strength, and perforation strength

    Storyboard

    Drew both storyboard scenes back when our focus was medication packaging for patients with reduced hand dexterity. Shown to the left are my cap and closure concepts, and to the right the test methods for opening torque, cap tensile strength, and perforation strength.

    Whiteboard draft of Team 11's project canvas, handwritten in red marker: partners, resources, activities, value proposition, mentors, channels and customer segments
    Team 11's project canvas slide from October 21, 2026, with color-coded sticky notes for each canvas section

    Project Canvas

    Our team canvas from October 21, shown as the whiteboard draft and the final slide. Reviewed the assignment requirements and put together our GA8 submission.

    Gantt chart of Team 11's prototype plan from October to December 2026, with the Order Parts row owned by Kimbel outlined

    Planning

    Our team prototype plan. I am in charge of ordering parts, shown in the outlined row.

    The 13 biological and chemical hazards from the Rev. 1 Initial Hazards Analysis, grouped into chemical, biological, immunological and performance categories and rated low, medium or high

    Hazard Analysis

    Wrote these 13 biological and chemical hazards with a teammate, proofread the full Initial Hazards Analysis, and added the severity scale.

    Prototyping

    Teammates built the foam core prototype and the CAD model. I am assigned to 3d print the mid-resolution prototype, due November 13.